Monday, April 18, 2011


Little by little, we're getting there.

Getting everything symmetrical and making templates for the various sections. It's finally starting to pull together. (The poorly-plugged hole near the front is just because I was tired of looking halfway through the gun while working. The foam will be removed and some electronics will go inside later on.)

Sunday, April 3, 2011

Laser gun update


Sanding, patching, sanding, patching. Wouldn't have to if I had done it right from the beginning...
But we'll get there.

Lesson to be learned: buy blocks of foam, glue them togther. Measure out your shape and draw it on the foam, then cut/hotwire it. Then do the details. When you're too cheap to buy foam, you will waste hours fixing the problems that cobbling together bits of foam causes for you.